Assigning Ip Addresses Using The Agilent Bootp Service - Agilent Technologies 1220 Infinity II LC User Manual

4
LAN Configuration
Automatic Configuration with BootP
5 Uncheck the Do you want to log BootP requests? box after configuring
Determining the MAC address directly from the LAN Interface card label
1 Turn off the instrument.
2 Read the MAC address from the label and record it.
3 Turn on the instrument.

Assigning IP Addresses Using the Agilent BootP Service

The Agilent BootP Service assigns the Hardware MAC address of the
instrument to an IP address.
Determining the MAC address of the instrument using BootP Service
1 Power cycle the Instrument.
2 After the instrument completes self-test, open the log file of the BootP
02/25/10 15:30:49 PM
Status: BootP Request received at outermost layer
Status: BootP Request received from hardware address: 0010835675AC
Error: Hardware address not found in BootPTAB: 0010835675AC
Status: BootP Request finished processing at outermost layer
74
changes. See "Stopping the Agilent BootP Service"
"Restarting the Agilent BootP Service"
instruments; otherwise, the log file will quickly fill up disk space.
The MAC address is printed on a label on the rear of the module. It is the
number below the barcode and after the colon (:) and usually begins with
the letters AD, see Figure 9
Service using Notepad.
• The default location for the logfile is C:\Documents and Settings\All Users\
Application Data\Agilent\BootP\LogFile.
• The logfile will not be updated if it is open.
The contents will be similar to the following:
on page 78.
on page 60 and Figure 10
1220 Infinity II LC System User Manual
on page 77 or
on page 61.