Setup (Dhcp) - Agilent Technologies 1220 Infinity II LC User Manual

Setup (DHCP)

The DHCP functionality is available on all Agilent HPLC modules with on-board LAN
Interface or LAN Interface Card G1369C, and "B"-firmware (B.06.40 or above) or modules
with "D"-firmware. All modules should use latest firmware from the same set.
1 Note the MAC address of the LAN interface (provided with G1369C LAN
1220 Infinity II LC System User Manual
Interface Card or Main Board). This MAC address is on a label on the card
or at the rear of the main board, e.g. 0030d3177321.
On the Instant Pilot the MAC address can be found under Details in the LAN
section.
Figure 14 LAN Setting on Instant Pilot
Dynamic Host Configuration Protocol (DHCP)
LAN Configuration
67
4