The Instrument Utility / Lab Advisor Software
During the installation process of the instrument this software is used for
flushing the system and performing the System Installation check (see
"Priming the System and Performing the 'Installation Check'"
1 Install the Instrument Utility or Lab Advisor software according to the
2 Setup your Instrument to the software and Connect it.
Whenever a hardware upgrade (Isocratic to Gradient, Column Oven, Autosampler upgrade)
N O T E
has been installed, it is necessary to re-configure your instrument in the Instrument Utility
/ Lab Advisor software. Therefore please follow the steps that are described in
"Configuration of the Instrument After an Upgrade Installation"
proceed.
1220 Infinity II LC System User Manual
Installation Procedure on the software CD.
The Instrument Utility / Lab Advisor Software
Installation
on page 49).
on page 48 before you
3
47