Ipv6 Netstream Configuration Task List; Enabling Ipv6 Netstream - H3C S5820X Series Configuration Manual

IPv6 NetStream Configuration Task List

Before configuring IPv6 NetStream, you need to make sure your requirements and decide to
make proper configurations accordingly.
Make sure on which device you want to enable IPv6 NetStream, that is, the NDE.
If multiple service flows are passing the NDE, you can use an QoS policy to select the
target data.
If there are enormous traffic flows on the network, you can configure NetStream sampling.
Configure the timer for NetStream flow aging.
If you want to reduce the bandwidth usage used by IPv6 NetStream data export, configure
IPv6 NetStream aggregation.
Complete
Enabling NetStream
Configuring NetStream
Data Export
Configuring Attributes of NetStream Export Data

Enabling IPv6 NetStream

Follow
To do...
Enter system view
Enter interface view
Enable NetStream
these tasks
Task
Configuring NetStream Common
Data Export
Configuring NetStream
Aggregation Data Export
these steps
system-view
interface interface-type
interface-number
ip netstream { inbound | outbound }
to configure
to enable
Use the command...
14-5
IPv6
Remarks
Required
Select a command accordingly
Optional
IPv6
Remarks
—
—
Required
Disabled by default.
NetStream:
NetStream: