Displaying And Maintaining Vrrp For Ipv4; Configuring Vrrp For Ipv6; Ipv6-Based Vrrp Configuration Task List - H3C S9500 Series Operation Manual

Operation Manual – VRRP
H3C S9500 Series Routing Switches
Note:
For detailed description on the snmp-agent trap enable vrrp command, refer to
command snmp-agent trap enable in SNMP Commands in the System Volume.

1.2.8 Displaying and Maintaining VRRP for IPv4

To do...
Display VRRP
status
Display VRRP
statistics
Remove VRRP
statistics

1.3 Configuring VRRP for IPv6

1.3.1 IPv6-Based VRRP Configuration Task List

Complete these tasks to configure VRRP for IPv6:
Enabling Users to Ping Virtual IPv6 Addresses
Configuring the Association Between Virtual IPv6 Address
and MAC Address
Creating VRRP Group and Configuring Virtual IPv6 Address
Configuring Priority, Preemption Mode and Interface Tracking
Configuring VRRP Packet Attributes
Caution:
VRRP is not supported on the VLAN interfaces of Super VLAN. Do not configure VRRP
on this type of interfaces.
Use the command...
display vrrp [ verbose ] [ interface
interface-type interface-number [ vrid
virtual-router-id ] ]
display vrrp statistics [ interface
interface-type interface-number [ vrid
virtual-router-id ] ]
reset vrrp statistics [ interface
interface-type interface-number [ vrid
virtual-router-id ] ]
Task
1-17
Chapter 1 VRRP Configuration
Remarks
Available in any
view
Available in any
view
Available in user
view
Remarks
Optional
Optional
Required
Optional
Optional