Qinq Configuration Examples; Basic Qinq Configuration Example - H3C S7500E-X Configuration Manual

QinQ configuration examples

Basic QinQ configuration example

Network requirements
As shown in
•
The service provider assigns VLAN 100 to Company A's VLANs 10 through 70.
•
The service provider assigns VLAN 200 to Company B's VLANs 30 through 90.
•
The devices between PE 1 and PE 2 in the service provider network use a TPID value of
0x8200.
Configure QinQ on PE 1 and PE 2 to transmit traffic in VLANs 100 and 200 for Company A and
Company B, respectively.
For the QinQ frames to be identified correctly, set the SVLAN TPID to 0x8200 on the service
provider-side ports of PE 1 and PE 2.
Figure 58 Network diagram
Configuration procedure
Configure PE 1:
1.
# Configure GigabitEthernet 1/0/1 as a trunk port, and assign it to VLAN 100.
<PE1> system-view
[PE1] interface gigabitethernet 1/0/1
[PE1-GigabitEthernet1/0/1] port link-type trunk
[PE1-GigabitEthernet1/0/1] port trunk permit vlan 100
# Configure VLAN 100 as the PVID for GigabitEthernet 1/0/1.
[PE1-GigabitEthernet1/0/1] port trunk pvid vlan 100
# Enable QinQ on GigabitEthernet 1/0/1.
[PE1-GigabitEthernet1/0/1] qinq enable
[PE1-GigabitEthernet1/0/1] quit
Figure 58:
195