To do...
Enter QinQ view and configure the
outer VLAN tag for the port to add
Tag frames of specific inner VLANs
with the outer VLAN
CAUTION:
•
An inner VLAN tag corresponds to only one outer VLAN tag.
If you want to change the outer VLAN tag, you must delete the old outer VLAN tag configuration and
•
configure a new outer VLAN tag.
Configuring the TPID value in VLAN tags
Follow these steps to configure the TPID value:
To do...
Enter system view
Enter interface
view or port
group view
Configure the TPID value in the VLAN tag
NOTE:
The TPID value configured on the S5120-SI Switch Series applies to both the CVLAN tags and the SVLAN
tags.
QinQ configuration examples
Basic QinQ configuration example
Network requirements
As shown in
The two branches of Company A, Site 1 and Site 2, are connected through the service provider
•
network and use CVLANs 10 through 70. The two branches of Company B, Site 3 and Site 4, are
connected through the service provider network and use CVLANs 30 through 90.
PE 1 and PE 2 are edge switches on the service provider network and are connected through
•
third-party devices with a TPID value of 0x8200.
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view
Enter port group view
Figure
47:
Use the command...
qinq vid vlan-id
raw-vlan-id inbound { all |
vlan-list }
Use the command...
system-view
interface interface-type
interface-number
port-group manual
port-group-name
qinq ethernet-type hex-value
149
Remarks
Required
By default, the default VLAN tag
of the receiving port is added as
the outer VLAN tag.
Required
Remarks
—
Required
Use either command.
Optional
0x8100 by default