Displaying And Maintaining The Tftp Client; Tftp Client Configuration Example - H3C S7500E Series Operation Manual

Operation Manual – File System Management
H3C S7500E Series Ethernet Switches

3.3 Displaying and Maintaining the TFTP Client

Display the configuration
of the TFTP client

3.4 TFTP Client Configuration Example

I. Network requirements
Use a PC as the TFTP server and your device as the TFTP client.
PC uses IP address 1.2.1.1./16 and a TFTP working directory has been defined
for the client.
On your device, VLAN-interface 1 is assigned an IP address 1.1.1.1/16. Make
sure that the port connected to PC belongs to the same VLAN.
TFTP a startup file from PC for upgrading and a configuration file config.cfg to PC
for backup.
II. Network diagram
Figure 3-2 Smooth upgrading using the TFTP client function
III. Configuration procedure
1) Configure PC (TFTP Server), the configuration procedure omitted.
On the PC, enable TFTP server
Configure a TFTP working directory
2) Configure the Switch (TFTP Client)
Caution:
If the free memory space of the device is not large enough, you should delete the
existing programs before downloading new ones.
# Enter system view.
<Sysname> system-view
To do...
display tftp client
configuration
Use the command...
3-4
Chapter 3 TFTP Configuration
Remarks
Available in any view