Table 82: Management Ip Filter Commands - Edge-Core ECS3510-28T Management Manual

M IP F
ANAGEMENT ILTER
management
Max Request : 2
Operation Mode : Multi-host
Port Control : Auto
Intrusion Action : Block traffic
Supplicant : 00-e0-29-94-34-65
Authenticator PAE State Machine
State : Authenticated
Reauth Count : 0
Current Identifier : 3
Backend State Machine
State : Idle
Request Count : 0
Identifier(Server) : 2
Reauthentication State Machine
State : Initialize
Console#
This section describes commands used to configure IP management access
to the switch.

Table 82: Management IP Filter Commands

Command Function
management Configures IP addresses that are allowed management
access
show management Displays the switch to be monitored or configured from
a browser
This command specifies the client IP addresses that are allowed
management access to the switch through various protocols. A list of up to
15 IP addresses or IP address groups can be specified. Use the no form to
restore the default setting.
S
YNTAX
[no] management {all-client | http-client | snmp-client |
telnet-client} start-address [end-address]
all-client - Adds IP address(es) to all groups.
http-client - Adds IP address(es) to the web group.
snmp-client - Adds IP address(es) to the SNMP group.
telnet-client - Adds IP address(es) to the Telnet group.
start-address - A single IP address, or the starting address of a
range.
– 855 –
| Authentication Commands
C 23
HAPTER
Management IP Filter
Mode
GC
PE