The following figure shows an example of routing a cable from a Controller to a
Drive Enclosure, both of which are located in the same rack.
Figure 74: Routing a cable same rack (Controller to Drive Enclosure)
Legend
1 Back of a rack
2 Controller
If there is excess length after routing and connecting the SAS cables, use one of
the following methods to manage the excess cable length:
Spool the excess cable length at the bottom of the rack and slide the cable
•
between the rack rail and the side panel. Use an anchor point that is not a
FRU, CRU, or another cable.
Identify an open space between the rack rail and the side panel and spool
•
the excess cable length so that it can occupy the open space. Use an anchor
point that is not a FRU, CRU, or another cable.
3 CMA
4 Drive Enclosure
Oracle FS System Cables
114