Install The Rack Rails For The Pilot; Figure 42: Pilot Rail Kit Parts - Oracle FS1-2 Installation Manual

CMA with six pre-installed cable clips
•
Four M4 x 5 fine-pitch mounting bracket securing screws (optional)
•
Manufacturer's instruction sheet
•
Tip: Ensure that you have all of the parts in the Pilot rail kit before you begin the
installation of the Pilot rails on the rack and the Pilot chassis.
Note: To locate part numbers for the rail kits, open
(https://support.oracle.com/handbook_private/index.html) and go to the
Oracle FS1 Flash Storage System components list. Part numbers are listed in the
components list.
The following figure shows the parts in the Pilot rail kit.

Figure 42: Pilot rail kit parts

Legend
1 Slide rails
2 Mounting brackets
3 Four M4 x 5 fine pitch mounting bracket securing screws (optional)
4 Installation card

Install the Rack Rails for the Pilot

Install the rack rails on the rack prior to installing the Pilot.
Prerequisite:
Ensure that you have adequate room to work around the rack while installing the
rails and the Pilot.
1 Place the rack-mount installation card against the front rails to identify the
correct mounting holes for the slide rails.
Install Component Rails
Oracle System Handbook
75