Table 14: Site preparation checklist (continued)
Check
Site preparation or pre-installation planning items
❑
Check the Oracle Technology Network (OTN) (http://www.oracle.com/
technetwork/documentation/oracle-unified-ss-193371.html) for all relevant
documentation:
For instructions on system unpacking, installation, and initial
•
configuration, refer to this guide.
For instructions on installing software updates, refer to the
•
Oracle FS1-2 Flash Storage System Release Notes and to the
Oracle Flash Storage System Administrator's Guide.
For instructions on configuring the system, refer to the Oracle
•
Flash Storage System Administrator's Guide.
For instruction on servicing the replaceable units within the
•
system, refer to the Oracle FS1-2 Flash Storage System Field
Service Guide.
Data path interface requirements
❑
Ensure that data path interfaces or connectors meet Oracle specifications
and speed requirements.
Network connectivity requirements
❑
Two 1 Gb/10 Gb Ethernet network cables, one for each Pilot to enable Pilot
connectivity to the management network.
❑
Obtain three IP addresses for the Pilot management interfaces. The shared
IP address may be assigned using DHCP. The address for each Pilot may
not be assigned using DHCP. DNS hostnames for the Pilot management
interfaces are optional, but recommended. The standard Pilot
configuration or the Oracle FS System factory default IP addresses are as
follows:
Shared IP: 10.0.0.2
•
Pilot–1: 10.0.0.3
•
Pilot–2: 10.0.0.4
•
Gateway: 10.0.0.1
•
Netmask: 255.255.255.0
•
Global system parameters
❑
The Oracle FS System defaults to the correct Call-Home connection
parameters and IP addresses, if it uses a direct connection to the Oracle
servers. If you are using a Proxy server, the information on the Call-Home
connection parameters and IP addresses comes from the local network and
firewall administrators. Get the Call-Home configuration modes from the
site network and/or firewall administrators.
Oracle FS Systems: Installation Overview
30
Need help?
Do you have a question about the FS1-2 and is the answer not in the manual?
Questions and answers