Table of Contents
Advertisement
You can test the Call‑Home settings from the Networking overview page of the
System tab.
Related Links
Auto Service Requests
Settings for ASR (Call-Home)
Activate ASR (Test Call-Home)
Activate ASR (Test Call-Home)
After you have configured Call‑Home for the Auto Service Request (ASR)
feature, send an ASR activation request to My Oracle Support (MOS).
Prerequisites:
•
•
•
1
Navigate to System > Global Settings > Networking.
2
To send the ASR activation request, select Actions > Test Call‑Home.
3
Confirm that you want to send test Call‑Home information, and click OK.
The Call‑Home test is an ASR activation request in MOS. MOS should
receive your request in a few minutes, but no longer than 60 minutes.
Note: You can repeat the activation request again, as necessary.
You or the customer user administrator (CUA) performs the following steps to
verify that the ASR activation request was successful.
4
Verify the receipt of an email from MOS with instructions to complete the
ASR activation process.
For information that describes how to complete the activation process,
login to
article titled "How to complete Auto Service Request (ASR) asset activation
using My Oracle Support."
5
Log in to MOS and verify that the ASR asset status shows "pending".
An "inactive" state means that MOS has not received your activation
request.
If you did not receive an email from MOS, or if the ASR asset in MOS is
"inactive", then perform the detailed ASR activation (Call‑Home)
troubleshooting.
Note: Do not contact Oracle Customer Support until you have completed the
troubleshooting checks.
Call‑Home is configured to access the ASR functions in MOS.
Event triggering and periodic triggering for Call‑Home are enabled and, the
parameters are set to the default settings.
Administrator privileges exist to the ASR asset that is registered in MOS.
My Oracle Support
(https://support.oracle.com/). Search for the
Configure Global Settings
176
Advertisement
Table of Contents
