Adjustment Of The Wiper Height - MIMAKI JV300-130 Maintenance Manual

MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjustment of the Wiper Height
Model JV300-130/160 Issued 2014.05.30 Revised

4.3.4 Adjustment of the Wiper Height

 Outline
Adjust the height of the wiper.
 Procedure
Wiper unit
Wiper base
Nozzle surface
1.5 mm
Wiper
© 2014 MIMAKI ENGINEERING CO.,LTD.
1. Loosen the wiper height adjusting screws (x2)
Screws
2. Adjust the distance in the left figure until the thickness gauge is
8 mm.
30
CA base
3. Loosen the screw and the miniature clamp lever on the P cover
U front, and then tighten the screws while holding the height
adjustment lever in the lowest position to fix the head in place.
4. Move the wiper base 30, and adjust the wiper so that there is
approximately 1.5 mm from the nozzle surface.
F/W ver. 1.00 Remark
Rev.
1.0
1
2
3
4
5
6
7
8
4.3.4 R.1.0 P.1