Table of Contents
Advertisement
Adjustment of the Table Height [TBL HEIGHT]
According to an used media, you need to adjust height of the table. If the height is not
proper, you can not print images properly.
Also, if the height is not adjusted, print quality may deteriorate, or media or the printer may
be damaged, which is very dangerous. When a media which is not the same as the last
one, make sure to adjust height of the table.
Gap adjustment between table surface and head undersurface is adaptable from 1.2 mm to
3.2mm. As for recommendation value of gap is 1.2mm. Therefore media thickness is ac-
ceptable up to 2.0mm.
STEPS:
1. Set a media.
Roll media: Tension and vacuum are turned on
Leaf media: Turn on the [Vacuum] of the sub
• To avoid interference of the head and
the media, lower the table sufficiently
before adjusting height.
2. Touch the [FUNCTION] in the LOCAL
mode.
3. Touch the JOG [ ] or [ ] to select the
[MAINTENANCE].
4. Touch the [ENTER].
5. Touch the JOG [ ] or [ ] to select the
[TBL HEIGHT].
6. Touch the [ENTER].
When the UV lamp is turned on, a massage which
ask you to turn it off is displayed. Follow the
message and turn off the UV lamp.
7. Touch the [ENTER].
automatically.
switch by hand.
- 2-22 -
FUNCTION
DATA CLEAR
FUNCTION
MAINTENANCE
MAINTENANCE
LIST
MAINTENANCE
TBL HEIGHT
TABLE HEIGHT ADJ
SET MEDIA
TABLE HEIGHT ADJ
COMPLETED
< ENT >
< ENT >
< ent >
< ent >
: ent
: ent
Advertisement
Table of Contents
