Switchport Native Vlan - Edge-Core ES3510MA Management Manual

E
XAMPLE
The following shows how to set the configuration mode to port 1, and then
set the switchport mode to hybrid:
R
ELATED
switchport acceptable-frame-types (790)
This command configures the PVID (i.e., default VLAN ID) for a port. Use
switchport native
the no form to restore the default.
vlan
S
YNTAX
D
EFAULT
VLAN 1
C
OMMAND
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
◆
◆
E
XAMPLE
The following example shows how to set the PVID for port 1 to VLAN 3:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#
C
OMMANDS
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port. (Range: 1-4093, no leading
zeroes)
S
ETTING
M
ODE
U
SAGE
When using Access mode, and an interface is assigned to a new VLAN,
its PVID is automatically set to the identifier for that VLAN. When using
Hybrid mode, the PVID for an interface can be set to any VLAN for
which it is an untagged member.
If acceptable frame types is set to all or switchport mode is set to
hybrid, the PVID will be inserted into all untagged frames entering the
ingress port.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#
– 793 –
| VLAN Commands
C 34
HAPTER
Configuring VLAN Interfaces