Modifying A Sequence; Editing Sample Log Table To Modify A Sequence - Agilent Technologies 7500 ICP-MS Operator's Manual

Agilent 7500 ICP-MS ChemStation Operator's Manual
Setting Up a Sequence

Modifying a Sequence

You can modify a sequence when you edit the Sample Log Table, and also by select-
ing different Sequence Options.

Editing Sample Log Table to Modify a Sequence

Before you can edit a Sample Log Table for the sequence you want to modify, you
must load the sequence into memory. See Steps 1 and 2 of "Simulating a
Sequence" in this chapter. Once the sequence is loaded, complete the following
steps:
>>
1 Select Sequence
The Sample Log Table appears.
2 Edit the fields to make changes to the sequence.
For information about the fields in the sample log table, see "Creating a Sequence"
in this chapter.
3 Click OK.
The Sample Log Table closes and changes are saved in the memory. If you exit
ChemStation without saving the sequence, the changes you made to the Sample Log
Table are lost. To save the sequence file to disk and assign a name to the sequence,
you must save the sequence. See "Saving the Sequence" in this chapter.
Edit Sample Log Table.
6-19