Loading Factors From A Calibration File - Agilent Technologies 7500 ICP-MS Operator's Manual

1 Click Load Factors from Calib.
2 To load data from a calibration file that is being edited and has not been saved,
3 Select a calibration file using one of the following methods.
N O T E
Agilent 7500 ICP-MS ChemStation Operator's Manual
Performing a Semiquantitative Analysis

Loading Factors from a Calibration File

ChemStation enables you to load semiquantitative factors from a calibration file.
The SemiQuant Parameters dialog box will appear.
SemiQuant Parameters Dialog Box
click Yes. To load data from an existing calibration file, click No.
Clicking No will bring up the Select Calibration File dialog box.
Select Calibration File dialog box.
• Select a file name from the displayed list and click OK.
• Double-click a file name in the displayed list.
• Enter a file name and click OK.
If multiple tune steps exist in the selected calibration file, the Select Tune Step dialog
box will appear. Select a tune step using this dialog box.
If multiple isotopes exist in the selected calibration file, the Select Mass dialog box
will appear. Select an isotope using this dialog box.
The Select Calibration File dialog box will close and the selected calibration file
will be loaded.
13-13