Setting Parameters For Isotope Analysis [Multi Tune] - Agilent Technologies 7500 ICP-MS Operator's Manual

Agilent 7500 ICP-MS ChemStation Operator's Manual
Creating a Method
Isotope Analysis [Multi Tune] Acquisition Parameters Dialog Box

Setting Parameters for Isotope Analysis [Multi Tune]

Because Isotope Analysis [Multi Tune] is similar to quantitative analysis in Spec-
trum Analysis [Multi Tune], setting the acquisition parameters is the same. Refer to
"Setting Parameters for Quantitative Analysis" on page 5-25 in this chapter to set
acquisition parameters for Isotope Analysis. Refer to "Setting Spectrum [Multi
Tune] Acquisition Parameters" on page 5-50 in this chapter for Multi Tune Parame-
ter Setting.
N O T E The Full Quant (3) in the Peak Pattern (left bottom) box is better than 1 point on the
Peak Pattern for Isotope Analysis.
5-64