Agilent Technologies 7500 ICP-MS Operator's Manual page 336

3 Select method sections to run.
4 Complete the dialog box.
N O T E
5 Click Run Sequence.
N O T E
Agilent 7500 ICP-MS ChemStation Operator's Manual
Running a Sample Analysis
Select Full Method if you are ready to acquire data.
Select Reprocessing Only if the data has already been acquired (e.g. if the data has
been acquired manually, or if you are reprocessing data files acquired previously in
a sequence).
This dialog box enables you to add comments about the sequence, set a pre- or
post-sequence macro or command to be executed, and to verify or correct the
directory path for the data files the sequence generates. You can create a new
directory as the destination for the data files simply by typing the desired path into
the Data File Directory field and running the sequence.
When the Print Sequence Log at Sequence Termination box is checked, the
sequence log is printed out upon completion of the sequence.
Any data files in the specified data file directory whose names are the same as those
in your Sample Log Table will be lost if the Overwrite Existing Data Files check box
is selected.
The analysis starts and the Run Sequence status box appears. This status box
remains open during the sample run. You can view a real-time display of the run
without closing the status box. See "Monitoring a Run" later in this chapter for
instructions.
Click OK to accept the edited information without executing the sequence.
Click Cancel to cancel the edited information.
8-6