Agilent Technologies 7500 ICP-MS Operator's Manual page 609

17 Select Start>>Programs>>ICP-MS ChemStation>>Edit hosts. Enter the IP
18 Reboot the computer.
19 Turn off the power of the Agilent 7500. Confirm the cable connection between
C A U T I O N
20 Start the ICP-MS ChemStation and download the firmware.
21 Go to standby mode.
CAUTION
Agilent 7500 ICP-MS ChemStation Operator's Manual
Installing the Agilent 7500 ChemStation Software (Windows 2000)
Address and the Host Name of Agilent 7500 which is setup in the Bootp Service.
Save the hosts file.
the Agilent 7500 and the computer. Then turn on the Agilent 7500.
After restarting the computer, turn off and turn on the Agilent 7500.
Double click ICP-MS Top.
When the ICP-MS Top window appears, download of the firmware starts
automatically. (it takes approximately 10minutes)
Select Vacuum>>Vacuum ON from the ICP-MS Instrument Control window to go
to standby mode.
Do not specify *.B, *.D, *.M, *.C, or long file names as ChemStation installation
destinations. If these are specified, there is a possibility that the various methods,
data, data batch, and calibration can not be loaded.
19-33