Applying A New Major Version Of An Axsm Sct To A Card Or Port - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Managing SCTs
In the following example, the user overwrites and old MPSM card SCT with a new one:
M8830_CH.2.PXM.a > cnfsct mpsm155 1 2 1 0xbc8cd86c
The cnfsct command does not cause a new SCT to become active on the card type you specify
with this command. To activate the new SCT on an individual card,you must reset the
standby card in a redundant pair or the active card in a non-redundant configuration
Do you want to proceed (Yes/No) ? y
Enter the dspscts command to ensure that the latest SCT version was registered on your switch. If the
Step 5
status is valid, the SCT is ready for use. The status of the SCT is marked as failed if the file does not
exist or does not match the major and minor versions. If the checksum computed for the file does not
match the checksum entered, the status is checksum mismatch.
Step 6 In order for the newer version of the SCT to take effect, you must reset each card that uses the SCT. The
procedure is different for different card types and configurations. Select the procedure that applies to
your situation from the following list:
•
•
•
Step 7 To verify that the new card SCT version has been applied to the appropriate card, use the cc command
to switch to that card, then enter the dspcdsct command.
Step 8 To verify that a new port SCT is in use on a card, use the cc command to switch to that card, then enter
the dspportsct gen <sctId> command.

Applying a New Major Version of an AXSM SCT to a Card or Port

The major version number of an AXSM SCT file changes when a new parameter is added to an SCT, or
when an existing parameter is deleted from an SCT. Only Cisco can warrant a major version change to
an SCT file, and as of the publishing date of this guide, no major version updates have been released.
Major version changes are posted in the Release Notes for Cisco MGX 8850 (PXM1E/PXM45), Cisco
MGX 8950, and Cisco MGX 8830 Switches, Release 5.0.00 and the Release Notes for the Cisco MGX
8880 Media Gateway, Release 5.0.00.
To apply a new major version of an SCT file to an AXSM card or port, use the following procedures:
Download the new SCT file to your switch, as described in
Step 1
Software Upgrades."
Establish a CLI management session at any user access level.
Step 2
Step 3 Enter the cc command to change to the appropriate AXSM (the card on which you will apply the new
SCT).
Step 4 Enter the setsctver <sctver> command. Replace <sctver> with the new SCT major version number.
M8850_SF.5.AXSM.a > setsctver 2
In order for the newer version of the SCT to take effect, you must reset the card. On a redundant pair,
Step 5
enter the switchredcd command to reset the card. On a standalone card, enter the resetcd command.
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
7-10
On a redundant pair of PXM1E cards or service modules, enter the switchredcd <fromSlot>
<toSlot> command.
On a standalone PXM1E card, enter the resetcd command.
On a standalone service module, enter the resetcd <slot> command at the PXM prompt.
Chapter 7 Managing Service Class Templates
Appendix A, "Downloading and Installing
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004