Adding Srm Cards - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Adding Cards
Step 4 When prompted to confirm the command and reset the card, type y and press Return.
After you confirm the command, the slot initializes, the runtime firmware loads on the service module
card, and the card resets. Be patient. The card reset takes a couple of minutes. While the card is resetting,
you can enter the dspcds command to display the status of the service module card. If you enter the
command frequently, you will see the card state change from Empty to Boot/Empty to Empty to
Init/Empty and finally to Active/Active.
Step 5 To verify that the new card is running the correct firmware, enter the dspcd command with the correct
slot number. The following example shows that the AXSM-XG card in slot 16 is running firmware
version 5.0(0).
M8950_DC.7.PXM.a > dspcd 16
M8950_DC
MGX8950 (JBP-2)
Slot Number:
Inserted Card:
Reserved Card:
State:
Serial Number:
Prim SW Rev:
Sec SW Rev:
Cur SW Rev:
Boot FW Rev:
800-level Rev:
800-level Part#:
CLEI Code:
Reset Reason:
Card Alarm:
Failed Reason:
Miscellaneous Information:
Type <CR> to continue, Q<CR> to stop:
After you confirm that the service module has been added and is running the correct software, you can
start bringing up lines as described in the appropriate service module software configuration guide.

Adding SRM Cards

When you add an SRM card to a switch, you are adding new front and back cards to a slot that is not
configured for an SRM card. The following procedure describes how to add SRM cards to unconfigured
slots.
If the slot has been previously configured for an SRM card, you can either replace that card with a card
Note
of the same type or you can decommission the slot.
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
10-4
System Rev: 05.00
16 Redundant Slot: NONE
Front Card
----------
AXSM-4-2488-XG
AXSM-4-2488-XG
Active
SAG06142PX4
5.0(0)
5.0(0)
5.0(0)
5.0(0)
03
800-16987-02
0
On Power up
NONE
None
Chapter 10
Mar. 31, 2004 06:22:26 GMT
Node Alarm: CRITICAL
Back Card
---------
SMF-4-2488-SFP
SMF-4-2488-SFP
Active
SAG06200DFZ
---
---
---
---
02
800-19913-02
0
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Switch Maintenance Procedures