Reattaching The Antenna End Cap; Applying New I/O End Cap Function Labels - Cisco 3200 Series Hardware Upgrade Manual

Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure

Reattaching the Antenna End Cap

Step 1
Step 2
Step 3
Step 4

Applying New I/O End Cap Function Labels

Step 1
Step 2
OL-15983-01
Get user manuals: See SafeManuals.com
To reattach the antenna end cap, follow these steps:
If you have added one or more WMICs, remove two of the corresponding plugs from the antenna end
cap and replace them with RP-TNC connectors.
Attach the antenna cables to the antenna end cap, as shown in
Attach the identification labels for the antennas to the antenna end cap.
Use a 3/8-inch socket wrench to secure the antenna end cap with 4 1/4-20x1.25-inch-long bolts. The
torque range for the antenna end cap bolts are 58 to 68 in-lb.
To apply new I/O end cap function labels, follow these steps:
Label the WMIC console ports.
If you have more than one WMIC installed in the router, remove the W2 plate on the I/O end cap and
replace it with the DB-9 console connector.
Figure 2-2.
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
2-19