Table 5-2 Parameters For T3 Line Configuration - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 5 Preparing SRM Cards for Communications
In the following example, the user displays the configuration for the T3 line connected to line 1 on the
SRM card in slot 7.
Lampoon.1.PXM.a > dspln -ds3 7.1
Line Number
Admin Status
Line Type
Line Coding
Line Length(meters) : 1
OOFCriteria
AIS c-Bits Check
Loopback
Xmt. Clock source
Rcv FEAC Validation : 4 out of 5 FEAC codes
To configure a T3 line, enter the cnfln command as follows:
Step 4
mgx8830b.1.PXM.a > cnfln -ds3 <slot.line> -lt <LineType> -len <LineLength> -oof
<OOFCriteria> -cb <AIScBitsCheck> -rfeac <RcvFEACValidation> -clk <clockSource>
Table 5-2
Table 5-2
Parameter
slot.line
-lt
-len
-oof
-cb
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
: 7.1
: Up
: dsx3CbitParity
: ds3B3ZS
: 3Of8Bits
: Check
: NoLoop
: localTiming
lists the parameter descriptions for configuring T3 lines.
Parameters for T3 Line Configuration
Description
If you are configuring a Cisco MGX 8850 (PXM1E/PXM45)
switch or an MGX 8880 Media Gateway, replace slot with 15
for an SRM in the upper bay, or 31 for an SRM in the lower
bay. If you are configuring a Cisco MGX 8830 switch,
replace slot with 7.
Replace line with the number that corresponds to the back
card port to which the line is connected.
T3 line type. Replace LineType with 9 to specify this line as
a dsx3M23 line, or 11 to specify the line as a dsx3CbitParity
line.
Specifies the line length. Replace <LineLength> with a
number to specify 0 through 64000 meters.
Specifies Out of Frame (OOF) criteria. Replace
<OOFCriteria> with 1 to specify a criteria of 3 out of 8
frames, or replace it with 2 to specify a criteria of 3 out of 16
frames.
Option 2, 3 out of 16 frames, is the only option
Note
supported on SRME/B cards.
Specifies the C-bit check. Replace <AIScBitsCheck> with 1
to check bits, or 2 to disable a bits check.
Note Option 1, check C-bits, is the only option supported
on SRME/B cards.
Setting Up SRM Lines
5-9