Updating Registered Sct Files - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 7 Managing Service Class Templates
Table 7-3
major ver
checksum
In the following example, FRSM card SCT 4, version 1, is registered on the switch.
M8850_SF.7.PXM.a > addsct frsm12 2 4 1 0x357d963a
You must enter this command once for each new SCT, or for each new major and minor version of a
pre-existing SCT.
Step 6 Enter the dspscts command and verify that the SCT file is registered on your switch.
The status of the SCT would be marked as "failed" if the file does not exist or does not match the major
and minor versions.

Updating Registered SCT Files

Once you have registered an SCT file on your switch, you can use the cnfsct command to update a
registered SCT with a different major or minor version of the same SCT. To update a registered SCT, use
the following procedure:
Step 1 FTP the new SCT file to the C:SCT/TEMP folder, as described in the
Switch" section in
Step 2 Establish a configuration session at any user access level.
Obtain the checksum for the SCT file you are registering. You can look up the checksum in the following
Step 3
release note documents:
•
•
Note
Enter the cnfsct command at the active PXM switch prompt.
Step 4
M8830_CH.2.PXM.a > cnfsct <card type> <sct type> <sct id> <major ver> <checksum>
The required parameters for this command are described in
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
addsct and cnfsct Command Parameters (continued)
Enter the major version number of the SCT file as it appears in the filename.
This number changes when a new parameter is added to a MIB. Only Cisco can
generate a new major version of a file.
Enter the hexadecimal SCT checksum number published in one of the
following documents:
Release Notes for Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950,
•
and Cisco MGX 8830 Switches, Release 5.0.00
• Release Notes for the Cisco MGX 8880 Media Gateway, Release 5.0.00
Appendix A, "Downloading and Installing Software Upgrades."
Release Notes for Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, and Cisco MGX 8830
Switches, Release 5.0.00
Release Notes for the Cisco MGX 8880 Media Gateway, Release 5.0.00
You will need the checksum for the cnfsct command in Step 4.
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
"Copying Software Files to the
Table 7-3.
Managing SCTs
7-9