Port Sct Abr Parameters (Dspportsct Abr); Table 7-7 Sct Abr Descriptions - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Managing PXM1E Port SCTs

Port SCT ABR Parameters (dspportsct abr)

The following report appears when you enter the dspportsct abr command:
M8830_CH.1.PXM.a > dspportsct abr 1
Service Class Template [
Major Version [
+----------------------------------------------+
|
+----------------------------------------------+
| VSI_SIGNAL(
|
| ATMF_VBRrt1(257)|DISABLED | DISABLED|
| ATMF_VBRrt2(258)|DISABLED | DISABLED|
| ATMF_VBRrt3(259)|DISABLED | DISABLED|
|ATMF_VBRnrt1(260)|DISABLED | DISABLED|
|ATMF_VBRnrt2(261)|DISABLED | DISABLED|
|ATMF_VBRnrt3(262)|DISABLED | DISABLED|
|
|
|
|
|
|
|
|
|
|
|
|
|
+----------------------------------------------+
Table 7-7
Table 7-7
Parameter
SERV-TYPE
CI CTRL
VSVD
1. RM = resource management
2. VSVD = virtual source/virtual destination
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
7-16
6] : VC ABR Parameters
1]
SERV TYPE | CI CTRL |
2)|DISABLED | DISABLED|
ATMF_CBR1(256)|DISABLED | DISABLED|
ATMF_UBR1(263)|DISABLED | DISABLED|
ATMF_UBR2(264)|DISABLED | DISABLED|
ATMF_ABR(265)| ENABLED | DISABLED|
ATMF_CBR2(266)|DISABLED | DISABLED|
ATMF_CBR3(267)|DISABLED | DISABLED|
TAG_COS0(512)|DISABLED | DISABLED|
TAG_COS1(513)|DISABLED | DISABLED|
TAG_COS2(514)|DISABLED | DISABLED|
TAG_COS3(515)|DISABLED | DISABLED|
TAG_COS4(516)|DISABLED | DISABLED|
TAG_COS5(517)|DISABLED | DISABLED|
TAG_COS6(518)|DISABLED | DISABLED|
TAG_COS7(519)|DISABLED | DISABLED|
describes the SCT ABR Parameters shown in the example.
SCT ABR Descriptions
Description
The service type (for example, CBR, VBR, ABR) to which the parameters in this
table apply (for example, COSB_NUM, CAC_TYPE, UPC_ENB).
Congestion indicator (CI) control. When enabled, this parameter specifies that the
CI field is an RM
an RM cell is sent, the source sets CI=1. When EFCI is received on a previous data
cell, CI=1.
2
When enabled, this parameter divides an ABR connection into two or more
separately controlled ABR segments. Each ABR control segment, except the first,
is sourced by a virtual source. Sources and destinations are linked through
bidirectional connections, and each connection termination point is both a source
and a destination, a source for data that is transmitting, and a destination for data
that is receiving.
: Minor Version [ 0]
VSVD |
1
cell that is used to cause the source to decrease the ACR. When
Chapter 7 Managing Service Class Templates
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004