Displaying Routing Policy Parameters; Displaying The Svcc Rcc Table - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 8 Managing PNNI Nodes and PNNI Routing
Table 8-19 Objects Displayed for the dsppnni-svcc-rcc-timer Command (continued)
Parameter
Retry time
Calling party integrity time
Called party integrity time

Displaying Routing Policy Parameters

Enter the dsppnni-timer command to display the routing policy parameters.
mgx8830a.1.PXM.a > dsppnni-timer
The following example shows the report for this command:
mgx8830a.1.PXM.a >
node index: 1
Hello holddown(100ms)...
Hello int(sec)..........
Hello inactivity factor.
Retransmit int(sec).....
AvCR proportional PM....
AvCR minimum threshold..
Peer delayed ack int(100ms)...................
Logical horizontal link inactivity time(sec)..

Displaying the SVCC RCC Table

Enter the dsppnni-svcc-rcc command to display the PNNI SVCC RCC Table.
mgx8830a.1.PXM.a > dsppnni-svcc-rcc [node-index] [svc-index]
If you specify both the node-index and the svc-index, the command displays information about an
SVCC-based RCC. If you specify only node-index, the command displays all SVC-based RCCs attached
to the svc-index node. If you specify no options, the command displays all SVC-based RCCs attached
to all PNNI nodes on this WAN as shown in the following example.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
dsppnni-timer
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Description
The amount of time (in seconds) this node will delay after an
apparently still necessary and viable SVCC-based RCC is
unexpectedly torn down, before attempting to re-establish it. The
range is from 10 to 60.
When the node initiates an SVCC as a calling party, this parameter
establishes the amount of time this node will wait for an SVCC to
become fully established. If the SVCC is not fully established at the
end of the configured time, it is torn down. The range is 5 to 300
seconds.
When the node receives an SVCC setup as the called party, this
parameter establishes the amount of time this node will wait for the
SVCC to become fully established. If the SVCC is not fully
established at the end of the configured time, it is torn down. The
range is 10 to 300 seconds.
10 PTSE holddown(100ms)...
15 PTSE refresh int(sec)..
5 PTSE lifetime factor...
5
50 CDV PM multiplier......
3 CTD PM multiplier......
Displaying Node Configuration Information
10
1800
200
25
50
10
120
8-55