Graceful Rpm Runtime Software Upgrades - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Multiservice switch
Table of Contents

Advertisement

Appendix A
Downloading and Installing Software Upgrades
Command
Step 12
enable
password
dir x:
show flash:
copy filename bootflash:
dir bootflash:
config terminal
boot bootldr bootflash:filename
^Z
show bootvar
copy bootflash:filename
x:filename
del bootflash:filename
show flash:
squeeze flash:
Step 13
switchredcd <secondarySlot>
<primarySlot>
Step 14

Graceful RPM Runtime Software Upgrades

The RPM cards support graceful upgrades when 1:N redundancy is established in the switch between
RPM cards.
In this document, the general term "RPM" refers to RPM-PR and RPM-XF cards. If a step or procedure
Note
is specific to only one of the RPM cards, it will be called out in the text.
The following quickstart procedure describes how to gracefully upgrade runtime software on redundant
RPM cards.
Redundancy must be established before you use this procedure. If redundancy has not been configured
Note
between two RPM cards, upgrade each RPM card as described in the
Software
"Establishing Redundancy Between RPM
Operation."
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Upgrades" section later in this chapter. To add redundancy to an RPM card, see the
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Purpose
Repeat Steps 4 through 9 to move the upgraded boot software into
bootflash.
This step makes the upgraded primary card active and resets the
secondary RPM card. When the secondary card resets, it loads the
upgraded boot software from bootflash. Both primary and
secondary cards should now be using upgraded boot software.
If there are other primary RPM cards that need upgrading, repeat
the part of this procedure that upgrades the primary card, then
enter the switchredcd command once to reload the primary card.
Finally, enter the switchredcd command a second time to make
the upgraded primary card active.
Cards" section in
Chapter 6, "Preparing RPM Cards for
Quickstart Procedures for Software Upgrades
"Non-Graceful RPM Runtime
A-17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mgx 8950Mgx 8830Mgx 8880

Table of Contents