Table 9-4 Cnfapsln Command Parameters - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Managing Redundant APS Lines
Table 9-4
Parameter
-w <working line>
-dr <direction>
-rv <revertive>
If you want to manually switch from one line to another, enter the switchapsln <bay> <line>
<switchOption> command, as shown in the following example:
mgx8830a.1.PXM.a > switchapsln 1 1 6
Manual line switch from protection to working succeeded on line 1.1.1
Table 9-5
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
9-22
cnfapsln Command Parameters (continued)
Description
Slot number, bay number, and line number of the active line to
configure, in the following format:
slot.bay.line
Example:
Determines whether the line is unidirectional or bidirectional.
•
•
Note
Example:
Determines whether the line is revertive or non-revertive.
•
•
Example:
describes the configurable parameters for the switchapsln command.
-w 1.1.1
1 = Unidirectional. The line switch occurs at the receive end of the
line.
2 = Bidirectional. The line switch occurs at both ends of the line.
This optional parameter is not shown in the above example
because you do not need to set it for a revertive line.
-dr 2
1 = Non-revertive. You must manually switch back to a recovered
working line.
2 = Revertive. APS automatically switches back to a recovered
working line after the number of minutes set in the -wtr
parameter.
-rv 1
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 9 Switch Operating Procedures