Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual page 521

Appendix A Downloading and Installing Software Upgrades
Command
Step 1
ftp
Step 2
copy
Step 3
username
password
Step 4
cc <RPM_Slot>
Step 5
enable
password
Step 6
show bootvar
Step 7 config terminal
Step 8 no boot system
Step 9 boot system x:filename
Step 10
boot config
e:auto_config_
Step 11 ^Z
copy run start
Step 12
show bootvar
Step 13 cc <active_PXM_slot>
resetcd <RPM_Slot>
Step 14
dspcds
dspcd <RPMR_Slot>
cc <RPM_Slot>
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Purpose
Copy the boot and runtime files you want to use to the switch
(C:FW).
See the
this appendix.
Copy and rename the runtime file to a generic name for easy
updates.
See the
section later in this chapter.
Note
Establish a CLI session with the active PXM card using a user
name at any access level.
Select the slot in which the RPM card is installed.
Enter Enable mode for the router.
Display the current runtime software filename.
Enter the router global configuration mode.
Remove the entire boot list. To remove a single file from the boot
list, include a filename. For example:
Router(config)# no boot system x:rpm-js-mz_122-4.T
Add the new router runtime image to the boot list. For example:
Router(config)# boot system x:rpm-js-mz.122-4.T
Configure the RPM card to store its configuration on the PXM
RPM_ hard disk.
slot#
Note
Exit global configuration mode and save the new configuration.
Verify the change in the runtime software filename.
This command sequence selects the active PXM card and restarts
the RPM card with the new runtime image.
Verify router reboot is complete.
Quickstart Procedures for Software Upgrades
"Copying Software Files to the
"Non-Graceful RPM Runtime Software
If you have already configured the RPM to use a generic
name, you can skip to Step 12.
This step only needs to be performed once. If this
command is already in the startup configuration file, you
do not need to enter it again.
Switch" section later in
Upgrades"
A-21