Configuring Ilmi On A Port; Configuring Ilmi Traps And Signaling - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

General PXM1E Configuration Procedures
Step 5 To verify that the new address has been assigned, enter the dspatmaddr command as shown in the
following example:
mgx8830a.1.PXM.a > dspatmaddr 2:2.2:1
Port Id: 2:2.2:1
Configured Port Address(es) :
47.1111.1111.1111.1111.1111.1111.1111.1111.1111.11
length: 160
scope: 0

Configuring ILMI on a Port

ILMI is optional on most ports. Use ILMI on a port when you want to do any of the following tasks:
•
•
•
•
ILMI is enabled by default on all signaling ports and remains in a down state until ILMI is started. There
are two ways to start ILMI on a port. To configure and start ILMI with a single command, use the cnfilmi
command. To start ILMI using the default values, enter the upilmi command. The following sections
describe how to
•
•
•
•
Note For information on additional ILMI management procedures, see the
Chapter 9, "Switch Operating Procedures."

Configuring ILMI Traps and Signaling

The default ILMI configuration uses the standard ILMI signaling VPI and VCI, sets three ILMI signaling
timers, and enables the distribution of ILMI management messages (traps) to SNMP managers such as
CWM. If the defaults are acceptable, you can start ILMI on the port entering the upilmi command. To
change the defaults and start ILMI, use the following procedure.
When ILMI is configured and started at one end of a link, it must be configured and started at the other
Note
end of the link before the link will operate properly.
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
3-60
type: internal
plan: nsap_icd
Use ILMI automatic configuration, which negotiates ATM communication parameters
Use ILMI address registration, which negotiates an ATM address for an attached CPE using an ILMI
prefix assigned to the port
Enable CWM auto-discovery on a link, which allows CWM to search for and discover Cisco
Systems switches that it can manage
Create a PNNI link to a BXM card on a BPX
Configure ILMI traps and signaling and start ILMI
Configure ILMI automatic configuration
Configure ILMI dynamic addressing
Start ILMI with the default trap and signaling parameters
Chapter 3
proto: local
redistribute: false
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Provisioning PXM1E Communication Links
"Managing ILMI"section in