Verifying Card Firmware Version Levels - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 4 Preparing Service Modules for Communication
To bring MPSM cards up to the Active/Active status, you must configure an interface type. For
MPSM-8-T1E1 cards, you must also configure a service. For more information, see the
MPSM Interfaces and

Verifying Card Firmware Version Levels

When you are having problems with your switch, or when you have taken delivery of a new switch but
delayed installation, it is wise to verify the firmware versions installed on the switch. If newer versions
of this firmware are available, installing the updated firmware can prevent switch problems.
To verify the firmware versions in use on your switch, use the following procedure.
To display the software revision status of all the cards in a switch, enter the dsprevs command as follows:
Step 1
M8850_LA.7.PXM.a > dsprevs
M8850_LA
MGX8850
Physical
Slot
--------
01
02
03
04
05
06
07
08
09
10
11
12
13
14
To see the software revision levels for a single card, enter the dspversion command as follows:
Step 2
8850_NY.1.AXSM.a > dspversion
Image Type
----------
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Services" section, which appears later in this chapter.
Logical Inserted
Slot Card
------- --------
01 AXSM_4OC12
02 ---
03 AXSM_16T3E3
04 ---
05 AXSME_2OC12
06 AXSM_16OC3_B
07 PXM45
07 PXM45
09 RPM_PR
10 ---
11 ---
12 ---
13 ---
14 ---
Shelf Type
----------
Runtime MGX
Boot MGX
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Managing Firmware Version Levels for Service Modules
System Rev: 02.01
Cur Sw
Revision
--------
2.1(60)
---
2.1(60)
---
2.1(60)
2.1(60)
2.1(60)
2.1(60)
---
---
---
---
---
---
Card Type Version
---------- ------------
AXSM 2.1(0)
AXSM 2.1(0)
Sep. 27, 2001 20:36:15 PST
Node Alarm: NONE
Boot FW
Revision
--------
2.1(60)
---
2.1(60)
---
2.1(60)
2.1(60)
2.1(60)
2.1(60)
---
---
---
---
---
---
Built On
------------
Feb 13 2001, 07:47:35
-
"Selecting
4-5