Table 8-7 Addcon And Cnfcon Preferred Route Command Parameters - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Managing PNNI Routes
Step 4 Associate the appropriate SPVC or SPVP to the preferred route you created in Step 2.
a. If you are associating a new SPVC or SPVP with the preferred route, enter the addcon command as
follows:
addcon <ifNum> <vpi> <vci> <serviceType> <mastership> -prefrte <preferredRouteId>
[-directrte <directRoute>]
Note
Table 8-7
b. If you are associating a previously created SPVC/SPVP with the preferred route, enter the cnfcon
command, as follows:
cnfcon <ifNum> <vpi> <vci> <serviceType> <mastership> -rtngprio <routingPriority> -prefrte
<preferredRouteId> [-directrte <directRoute>]
Note
Table 8-7
Note
Table 8-7
Parameter
ifNum
vpi
vci
mastership
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
8-16
For PXM1E cards, the addcon command is entered at the PXM card prompt. For all other cards,
the addcon command is entered at the service module prompt.
describes the parameters you can configure for the addcon command.
For PXM1E cards, the cnfcon command is entered at the PXM card prompt. For all other cards,
the addcon command is entered at the service module prompt.
describes the parameters you can configure for the cnfcon command.
There are other optional parameters that you can set using the addcon and cnfcon commands,
but they do not appear in Table 8-7
an SPVC or SPVP with a preferred route. For information on all the command parameters for
PXM1E cards, see Chapter 3, "Provisioning PXM1E Communication Links."
on all the addcon and cnfcon command parameters a service module, refer to the appropriate
service module guide, all of which are listed in
addcon and cnfcon Preferred Route Command Parameters
Description
Logical interface (or port) number. This ifNum corresponds to the ifNum
added through the addport command. The range is 1-31.
Virtual path identifier value in the range 0-255 (UNI) or 0-4095 (NNI or
VNNI). For VNNI, specify one VPI per port.
Virtual connection identifier (VCI):
For a VCC on a UNI, the range is 1-4095. On an NNI or VNNI, the VCI range
is 1-65535.
For MPLS, the recommended minimum VCI is 35.
For a VPC, the vci is 0.
Value to specify the endpoint as master or slave:
1 or `m' specifies the master end.
•
• 2 or `s' specifies the slave end.
Chapter 8
because you do not need to set them when you are associating
Table 1-1.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Managing PNNI Nodes and PNNI Routing
For information