Table of Contents
Advertisement
Managing PNNI Nodes
To view the status of the -transitRestricted option, enter the dsppnni-node command as shown in the
following example:
mgx8830a.1.PXM.a >
node index: 1
Level...............
Restricted transit..
Branching restricted
Admin status........
Non-transit for PGL election..
Node id...............56:160:47.00918100000100001a531c2a.00001a531c2a.01
ATM address...........47.00918100000100001a531c2a.00001a531c2a.01
Peer group id.........56:47.00.9181.0000.0100.0000.0000.00
Enabling and Disabling Point-to-Multipoint Branching
The branching restricted option allows you to enable or disable branching for point-to-multipoint calls.
When branching is enabled, the node can receive one source connection and branch that connection to
multiple cards and ports. When branching is disabled, a separate source connection is required for every
destination card or port. The default setting for this option enables branching for point-to-multipoint
calls.
To enable or disable branching in a node, enter the cnfpnni-node command as follows:
mgx8830a.1.PXM.a > cnfpnni-node <
Replace node-index with the index that identifies the logical node you are modifying, and enter either
on or off for the -branchingRestricted parameter. When this parameter is set to on, the node does not
branch connections. When the -branchingRestricted parameter is set to off, the node performs branching.
To view the status of the -branchingRestricted option, enter the dsppnni-node command as shown in the
following example:
mgx8830a.1.PXM.a >
node index: 1
Level...............
Restricted transit..
Branching restricted
Admin status........
Non-transit for PGL election..
Node id...............56:160:47.00918100000100001a531c2a.00001a531c2a.01
ATM address...........47.00918100000100001a531c2a.00001a531c2a.01
Peer group id.........56:47.00.9181.0000.0100.0000.0000.00
Adding an ATM Summary Address Prefix
Enter the addpnni-summary-addr command to add an ATM summary address prefix for a PNNI logical
node on the switch.
mgx8830a.1.PXM.a > addpnni-summary-addr <
[-suppress] [-state]
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
8-6
dsppnni-node
node name: 8850_LA
56
Lowest..............
on
Complex node........
on
up
Operational status..
off
node-index
dsppnni-node
node name: 8850_LA
56
Lowest..............
off
Complex node........
on
up
Operational status..
off
node-index
Chapter 8
Managing PNNI Nodes and PNNI Routing
true
off
> -branchingRestricted on|off
true
off
address
prefix
> <
-
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
up
up
prefix
length
> <
-
> [-type]
Advertisement
Table of Contents
Troubleshooting
