Chapter 9
Switch Operating Procedures
Step 4
Enter configure the port range, enter the following command:
mgx8830a.1.PXM.a > cnfpnportrange <portid> [-minsvccvpi <min-svcc-vpi>] [-maxsvccvpi
<max-svcc-vpi>]] [-minsvccvci <min-svcc-vci>] [-maxsvccvci <max-svcc-vci>]] [-minsvpcvpi
<min-svpc-vpi>] [-maxsvpcvpi <max-svpc-vpi>]]
The only required parameter for this command is the <portid> parameter, but the command serves no
purpose if you enter it without options. If you include some options with the command and omit others,
the omitted options remain set to the last configured values.
and parameters for this command.
Table 9-25 Parameters for the cnfpnportrange Command
Parameter
portid
min-svcc-vpi
max-svcc-vpi
min-svcc-vci
max-svcc-vci
min-svpc-vpi
max-svpc-vpi
Step 5
Enter the following command to bring up the PNNI port you just configured:
mgx8830a.1.PXM.a > uppnport <portid>
Replace <portid> using the format slot:bay.line:ifNum.
Step 6
To display the PNNI port range for a port, enter the following command:
mgx8830a.1.PXM.a > dsppnportrange <portid>
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Description
Port identifier in the format slot:bay.line:ifnum.
parameters.
Minimum VPI value for SVCC.
Range: 0 to 4095.
Default = 0.
Maximum VPI value for SVCC.
Range: 0 to 4095.
Default = 4095.
Minimum VCI value for SVCC.
Range: 32 to 65535.
Default = 35.
Maximum VCI value for SVCC.
Range: 32 to 65535.
Default = 65535.
Minimum VPI value for SVPC.
Range: 1 to 4095.
Default = 1.
Maximum VPI value for SVPC.
Range: 1 to 4095.
Default = 4095.
Configuring VPI and VCI Ranges for SVCs and SPVCs
Table 9-25
lists and describes the options
Table 9-1
describes these
Table 9-1
describes these parameters.
9-53