Moving Licenses From An Mpsm Card To The Switch; Allocating Feature Licenses To A Card - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Multiservice switch
Table of Contents

Advertisement

Appendix F
MPSM Licensing
--------------- -----
MultiSrvc 1
Channelize 1
RateControl 1
MultiLink 1
Please confirm the above licence information.
cnflic: Do you want to proceed (Yes/No)? y
M8850_SF.7.PXM.a >
Step 7
To verify that new licenses have been installed, enter the dsplics command.
Caution
To avoid losing licenses during a configuration restoration, save the switch configuration after installing
the new licenses by using the saveallcnf command.
Step 8
Enter the saveallcnf command.

Moving Licenses from an MPSM Card to the Switch

To move programmed licenses from an MPSM card to the switch license pool, use the cc command to
move to the CLI prompt for the MPSM card. Then enter the movelic command as follows:
M8250_SJ.1.22.MPSM8T1.FRM.a > movelic
------------------------------------------------
Programmed License Type #Programmed
----------------------- -----------
Rate-Control 1
Do you want to proceed (Yes/No)? Yes
Card Licenses have been moved to license pool.
M8250_SJ.1.22.MPSM8T1.FRM.a >
Note
The movelic command requires SERVICE_GP privileges.
In the above example, the movelic command moved all licenses programmed into the NVRAM on the
MPSM card into the PXM license pool. Licenses can be moved only once from a card to a license pool.
Licenses cannot be moved back to an MPSM card. If you want to transfer licenses to another switch, see
"Transferring Licenses Between
Caution
To avoid losing licenses during a configuration restoration, save the switch configuration after moving
the new licenses into the PXM license pool by using the saveallcnf command.

Allocating Feature Licenses to a Card

To allocate a feature license to an MPSM card, configure the card to use the licensed feature. For
example, to allocate the IMA feature to a card, use the addimagrp command to create an IMA group.
Licenses are also allocated to redundant cards, so if you use the addred command to configure a
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Switches."
MPSM Licensing Information
F-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mgx 8950Mgx 8830Mgx 8880

Table of Contents