Additional Pxm1E Information Configuration Worksheet - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Appendix E Hardware Survey and Software Configuration Worksheets
Table E-4
Feature
PXM and SRM
1. SRM cards do not operate in Cisco MGX 8950 switches.

Additional PXM1E Information Configuration Worksheet

Table E-5
PXM1E cards operate only on Cisco MGX 8850 (PXM1E) and Cisco MGX 8830 switches. If you are
Note
configuring a Cisco MGX 8850 (PXM45) or Cisco MGX 8950 switch, you do not need to fill out
Table
Table E-5
Feature
Card type
Standalone configuration
Redundant configuration
Card SCT
Line operation mode
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
General Switch Configuration Parameters (continued)
Time zone
Time zone offset
1
Redundancy Options
Standalone configuration Primary or secondary
Upper bay SRM
Lower bay SRM
Redundant configuration
Upper bay SRMs
Lower bay SRMs
lists the additional information you will need to configure PXM1E cards.
E-5.
Additional PXM1E Card Configuration Parameters
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Additional PXM1E Information Configuration Worksheet
Parameter Information Value to Configure
Enter a zone
Hours to offset
card set installed?
SRM-3T3 or SRME?
Bulk distribution?
SRM-3T3 or SRME?
Bulk distribution?
SRM-3T3 or SRME?
Bulk distribution?
SRM line redundancy?
SRM-3T3 or SRME?
Bulk distribution?
SRM line redundancy?
Parameter
Information Value to Configure
Front and back cards
installed
Using intracard APS?
APS connector
installed?
SCT number
T1, E1, T3, or E3?
E-7