Table 3-15 Cnfilmi Command Configuration Parameters - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 3 Provisioning PXM1E Communication Links
Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 1
If you want to preview the current ILMI configuration for a port, enter the dspilmis command. The
Step 2
following example shows the dspilmis command report:
mgx8830a.1.PXM.a > dspilmis
Sig. rsrc
Port Part State
---- ----
1
2
3
The example above shows that ILMI is enabled on port 1 (ILMI State = On) and is disabled on ports 2
and 3 (ILMI State = Off). All other ILMI parameters are set to the default values.
Note
Enter the cnfilmi command as follows:
Step 3
mgx8830a.1.PXM.a > cnfilmi -if <ifNum> -id <partitionID> [-ilmi <ilmiEnable>] [-vpi <vpi>]
[-vci <vci>] [-trap <ilmiTrapEnable>] [-s <keepAliveInt>] [-t <pollingIntervalT491>] [-k
<pollInctFact>]
Table 3-15

Table 3-15 cnfilmi Command Configuration Parameters

Parameter
ifNum
partitionID
ilmiEnable
vpi
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Ilmi Sig Sig Ilmi
Vpi Vci Trap
---- ---- ---- --- ------------
1 On 0 16
1 Off 0 16
1 Off 0 16
The ILMI state displayed by the dspilmis command is the configuration state, not the
operational state, which appears when you enter the dsppnports or dsppnilmi commands.
describes the parameters for the cnfilmi command.
Description
Interface number or port number. This number identifies the port on which you
are configuring ILMI. Enter the interface number that was assigned with the
addport command (see
Partition ID number. This number identifies the PNNI partition assigned to the
port. Enter the partition number that was assigned to the port with the addpart
command (see
Partition ID 1 is reserved for PNNI.
Note
ILMI enable parameter. To change the current state of ILMI, enter 1 to enable
or start ILMI or 2 to disable ILMI. Note that the default value is 1, which
causes ILMI to start whenever the cnfilmi command is entered, unless you
enter this parameter with value 2.
Default = 1 (enable).
ILMI signaling VPI. If you need to change the default, enter a VPI number in
the range of 0 to 255. Note that changing this value disables ILMI
communications until the device at the remote end of the line has been
configured for the same ILMI VPI.
Default = 0.
S:Keepalive T:conPoll K:conPoll
Interval Interval
---------- ----------
On 1
On 1
On 1
"Adding ATM
"Partitioning Port Resources Between
General PXM1E Configuration Procedures
InactiveFactor
5 4
5 4
5 4
Ports").
Controllers").
3-61