Displaying A List Of Connections; Table 3-19 Optional Parameters For The Dspcons Command - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

General PXM1E Configuration Procedures

Displaying a List of Connections

To display a list of connections on the current PXM1E card, enter the dspcons command as follows:
PXM1E_SJ.8.PXM.a > dspcons [-port portid] [-vpi starting-vpi] [-vci starting-vci] [-state
{fail|ok|down}]
[-persflag {nonpersistent | persistent}] [-rteid <pref-rte-id> ] [-type {p2p | p2mp}]
[-smconinfo {notavail | avail}]
You can enter the dspcons command without parameters, or you can include any of the parameters list
in Table

Table 3-19 Optional Parameters for the dspcons Command

Parameter
portid
starting-vpi
starting-vci
-state
-owner
-sc
-persflag
pref-rte-id
-type
-smconinfo
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
3-84
[-owner {master|slave}] [-sc {cbr | rtvbr | nrtvbr | abr | ubr}]
3-19.
Description
Limits the list of connections to all connections on the specified port. Specify the
port in the format [shelf.]slot[:subslot].port[:subport]. To display a list of the
available ports, enter the dspcons command without any options.
Limits the list of connections to all connections with a VPI equal to or greater
than the number you specify.
Limits the list of connections to all connections with a VCI equal to or greater
than the number you specify.
Limits the list of connections to all connections that are in the state you specify.
State options are down, fail, and ok.
Limits the list of connections to all connections that use the specified ownership
role, which is either slave or master.
Service class. This option limits the list of connections to all connections that use
the specified service class. Valid service classes are cbr, rtvbr, nrtvbr, abr, and
ubr.
Persistence flag. This option limits the list of connections to all connections that
match the specified persistence state, which is either nonpersistent or
persistent.
Preferred route ID. This option limits the list of connections to all connections
that operate on the specified route.
This option limits the list of connections to all connections that match the
specified connection type, which is either p2p or p2mp.
This option limits the list of connections to all connections that match the
specified level of available configuration information, which is either available
(avail) or not available (notavail).
Chapter 3 Provisioning PXM1E Communication Links
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004