Table 3-5 Cnfimagrp Command Parameters - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

General PXM1E Configuration Procedures
Table 3-5
-mode <autoRestart>
-rxid
<rxImaIdExpected>
Note
In the following example, the user modifies the transmit frame length, the IMA group uptime, and the
IMA group downtime:
M8830_CH.1.PXM.a > cnfimagrp -grp 2.1 -txfl 128 -uptim 100 -dntim 100
Step 5 To verify IMA group configuration changes, enter a dspimagrp command for the appropriate IMA
group.
M8830_CH.1.PXM.a > dspimagrp 2.1
Group Number
NE IMA Version
Group Symmetry
Tx Min Num Links
Rx Min Num Links
NE Tx Clk Mode
FE Tx Clk Mode
Tx Frame Len (bytes)
Rx Frame Len (bytes)
Group GTSM
NE Group State
FE Group State
Group Failure Status
Tx IMA ID
Rx IMA ID
Max Cell Rate (c/s)
Avail Cell Rate (c/s)
Diff Delay Max
Diff Delay Max Observed (msecs) : 0
Accumulated Delay (msecs)
Clear Accumulated Delay Status
GTSM Up Integ Time (msecs)
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
3-34
cnfimagrp Command Parameters (continued)
The -mode parameter is optional and configures the IMA autorestart feature.
The parameter options and the numbers that select them are:
• Disable autorestart for this IMA group = 1
Enable autorestart for this group and relearn the receive IMA ID during
•
autorestart = 2
Enable autorestart for this group and use the previously learned receive
•
IMA ID during autorestart = 3
Note
For more information on using this feature, see
in Chapter 9, "Switch Operating Procedures."
This optional parameter defines the receive IMA ID expected. This number
should match the transmit IMA ID (txid) configured at the far end of the IMA
link. A configured value of -1 (minus one) specifies that the IMA group
should learn the far end ID on restart. The range is -1 to 255.
For more information on using this feature, see
in Chapter 9, "Switch Operating Procedures."
Modifying any of the attributes causes the IMA group to restart.
(msecs)
Chapter 3
Before configuring the -mode option, you must enable IMA
autorestart for the card using the cnfimaparms command.
: 2.1
: 1.0
: Symm Operation
: 1
: 1
: CTC
: CTC
: 128
: 128
: Up
: Operational
: Operational
: No Failure
: 255
: 255
: 14367
: 14367
: 275
: 0
: Not In Progress
: 0
Provisioning PXM1E Communication Links
"Restarting an IMA
"Restarting an IMA
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Group"
Group"