Port 10-Gigabit + 16-Port Ge Combination Ethernet Line Card With Sfp And Sfp - Cisco ASR 9000 Series Installation Manual

Overview
4-Port 10-Gigabit + 16-Port GE Combination Ethernet Line Card with SFP and
SFP+
The 4-Port 10GE + 16-Port GE combination line card provides four cages for SFP+ Ethernet optical interface
modules that operate at a rate of 10 Gbps, and 8 double-stacked (16 total) cages for SFP Ethernet optical
modules that operate at a rate of 1 Gbps. This line card is available in either an -SE (Service Edge Optimized)
or -TR (Packet Transport Optimized) version. All versions are functionally equivalent, but vary in configuration
scale and buffer capacity.
Each SFP and SFP+ cage on the 4-Port 10GE + 16-Port GE combination line card has an adjacent Link LED
visible on the front panel. The Link LED indicates the status of the associated SFP or SFP+ port, as described
in Line Card LEDs, on page
The following figure shows the 4-Port 10GE + 16-Port GE combination line card front panel and connectors.
Note
The 4-Port 10GE + 16-Port GE combination line card comes with 16x1GE + 2x10GE ports enabled. The two
10GE ports that are enabled by default are Port16 and Port17. To enable the additional two 10GE ports, the
license must be enabled. Upon acquiring the license, Port18 and Port19 are enabled.
For information on enabling the license, see the Software Entitlement chapter in the Cisco ASR 9000 Series
Aggregation Services Router System Management Configuration Guide, Release 5.3.x. The license product
number for the A9K-4T16GE-TR card is A9K-2T-TR-LIC. The license product number for the
A9K-4T16GE-SE card is A9K-2T-SE-LIC.

4-Port 10-Gigabit + 16-Port GE Combination Ethernet Line Card with SFP and SFP+

138.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
23