Modifying Atm Ports - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 3 Provisioning PXM1E Communication Links
Step 5 To display a list of the ports configured on the PXM1E card, enter the following command:
mgx8830a.1.PXM.a > dspports
This command displays all configured ports on the PXM1E card. Port numbers are listed in the ifNum
(interface number) column. If you want to view information on a particular port, note the number of that
port.
Step 6 To display the port configuration, enter the following command:
mgx8830a.1.PXM.a > dspport <ifNum>
Replace <ifNum> with the number assigned to the port during configuration. The following example
shows the report for this command:
mgx8830a.1.PXM.a > dspport 1
Interface Number
Line Number
Admin State
Guaranteed bandwidth(cells/sec): 353207
Maximum bandwidth(cells/sec)
ifType
VPI number (VNNI, VUNI)
MIN VPI (EVNNI, EVUNI)
SCT Id (Conf./InUse)
F4 to F5 Conversion
Tip To change the port configuration, enter the cnfport command, or enter the delport command to delete
a port configuration. You can also activate and deactivate ports entering the upport and dnport
commands. For more information on these commands, refer to the Cisco MGX 8850 (PXM45/PXM1E),
Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Command Reference, Release 5.

Modifying ATM Ports

After you add a port, you can modify the following parameters with the cnfport command:
•
•
•
•
•
To modify an ATM port, use the following procedure.
Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 1
Step 2 Get the port number that you want to modify. To display a list of the ports configured on the PXM1E
card, enter the following command:
mgx8830a.1.PXM.a > dspports
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Minimum cell rate
Maximum cell rate
Port SCT ID
Minimum VPI for EVUNI and EVNNI
Maximum VPI for EVUNI and EVNNI
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
: 1
: 2.3 IMA Grp Number
: Up Operational State
Number of partitions
: 353207 Number of SPVC
: NNI Number of SPVP
: 0 Number of SVC
: 0 MAX VPI (EVNNI, EVUNI): 0
: 0/0=Def
: Disabled
General PXM1E Configuration Procedures
: N/A
: Up
: 1
: 0
: 0
: 3
3-47