Deleting An Ncdp Clock Source; Table 9-21 Delncdpclksrc Command Objects - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Managing NCDP Clock Sources
Table 9-20 dspncdpport Command Objects
Parameter
PCR
SCR
MBS
1. PCR = peak cell rate
2. SCR = sustained cell rate
3. MBS = maximun burst size

Deleting an NCDP Clock Source

Enter the delncdpclksrc <portid> [clocktype <e1 | t1>] command to delete a clock source from the
network. describes how to set the <portid> and [clocktype] parameters on all possible switches and
cards.

Table 9-21 delncdpclksrc Command Objects

Parameter
portid
clocktype
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
9-40
Description
1
Displays the PCR
2
Displays the SCR
Displays the MBS
Description
The format of the PNNI physical port identifier can vary, as follows:
• On a PXM45: slot:subslot.port:subport
• On a PXM1E for UNI/NNI back card: slot:subslot.port:subport. On
the UNI/NNI back card, the subslot is always 2, but the slot depends
on the chassis, as follows:
– In an MGX 8850 chassis, slot is always the logical slot 7.
– In an MGX 8830 chassis, slot is always the logical slot 1.
On a PXM1E for a service module: slot.port.
•
For BITS clocks only, the default portid is 7.35(for E1 ports) or 7.36 (for
T1 ports).In an MGX 8830 chassis, the default portid for BITS is either
1.35 (for E1 ports) or 1.36 (for T1 ports).
Note If the portid was modified, so that the BITS clocks portid
7.35/1.35 has been configured as a T1 (instead of an E1 port), or if
7.36/1.36 has been configured to be an E1 port (instead of a T1
port), then you must specify the clocktype in the delncdpclksrc
command.
Enter e1 or t1 as needed when the port ID is one of the following:
• 7.35 or 7.36 in an MGX 8850 or MGX 8950 switch or in an MGX
8880 Media Gateway
• 1.35 or 1.36 in an MGX 8830 chassis
If the clock type is the default E1, this parameter is not necessary for port
IDs 7.35 or 7.36 (or 1.35.or 1.36).
Default: e1
Chapter 9 Switch Operating Procedures
for the port.
for the port.
3
for the port.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004