Selecting A Port Sct - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 4 Preparing Service Modules for Communication
M8850_LA.1.AXSM.a > dspcd
Card Type:
State:
Serial Number:
Boot FW Rev:
SW Rev:
800-level Rev:
Orderable Part#:
PCA Part#:
CLEI Code:
Reset Reason:
Card Operating Mode: AXSM-A
SCT File Configured Version: 1
SCT File Operational Version: 1
Card SCT Id: 5
Type <CR> to continue, Q<CR> to stop:
Enter the upport <if> command to bring up any ports you brought down in Step 3. Replace <if> with
Step 6
the interface number of the downed port.
M8850_LA.1.AXSM.a > upport 1
Enter the dspports command to verify that all ports on the card are up.
Step 7
M8850_LA.1.AXSM.a > dspports
ifNum Line Admin Oper. Guaranteed Maximum
----- ---- ----- ----- ---------- --------- ------ ------ ------ ------ ------

Selecting a Port SCT

A port SCT defines queue parameters that apply to egress queues on a port. Port SCTs are configured
when provisioning ports. For more information on provisioning service module ports and configuring
port SCTs, refer to the configuration and command reference guide for the service module. These guides
are listed in
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Front Card
----------
AXSM-4-622
Active
SAK0350007N
3.0(0.171)P2
3.0(0.171)P2
09
800-5774-5
73-4504-2
BAA1BADAAA
Power ON Reset
State State Rate
1 2.1 Up Up 1412830
2 2.2 Up Up 1412830
3 1.1 Up Up 1412830
Table 1-1 in Chapter 1, "Preparing for Configuration."
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Upper Card
----------
SMFIR-2-622
Present
SAK0346003F
---
---
13
800-5383-1
73-4125-1
0000000000
SCT Id ifType
Rate (D:dflt
used)
1412830 5 NNI
1412830 5 NNI
1412830 5 NNI
Selecting a Port SCT
Lower Card
------------
SMFIR-2-622
Present
SBK043902FE
---
---
A1
800-5383-1
73-4125-1
BAI9ADTAAA
VPI minVPI maxVPI
(VNNI, (EVNNI,EVUNI)
VUNI)
0 0 0
0 0 0
0 0 0
4-11