Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual page 179

Chapter 3 Provisioning PXM1E Communication Links
Table 3-10 Parameters for the addpart Command (continued)
Parameter
minConns
maxConns
To display a list showing the resource partition you have created, enter the following command:
Step 4
mgx8830a.1.PXM.a > dspparts
To display the configuration of a specific resource partition, note the interface and partition numbers and
Step 5
enter the following command:
mgx8830a.1.PXM.a > dsppart <ifNum> <partId>
Table 3-10
The following example shows the report provided by the dsppart command.
mgx8830a.1.PXM.a > dsppart 1 1
Interface Number
Partition Id
Controller Id
egr Guaranteed bw(.0001percent): 1000000
egr Maximum bw(.0001percent)
ing Guaranteed bw(.0001percent): 1000000
egr Maximum bw(.0001percent)
min vpi
max vpi
min vci
max vci
guaranteed connections
maximum connections
Note
Note For more information on working with partitions, see the
Chapter 9, "Switch Operating Procedures."
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Description
Specifies the guaranteed number of connections. On the PXM1E UNI/NNI, the ranges
vary according to the line types, as follows:
For OC3, T3, and E3 lines, the range is 10-27000.
•
For T1 and E1 lines, the range is 10-13500.
•
Specifies the guaranteed number of connections. On the PXM1E UNI/NNI, the ranges
vary according to the line types, as follows:
• For OC3, T3, and E3 lines, the range is 10-27000.
• For T1 and E1 lines, the range is 10-13500.
describes the parameters for this command.
Partition ID 1 is reserved for PNNI.
: 1
: 1 Number of SPVC: 0
: 2 Number of SPVP: 0
Number of SVC : 0
: 1000000
: 1000000
: 0
: 4095
: 1
: 65535
: 10000
: 10000
"Managing PXM1E
General PXM1E Configuration Procedures
Partitions" section in
3-51