Table of Contents
Advertisement
Chapter 9
Switch Operating Procedures
MGX8850.7.PXM.a > dspcontrollers
Controller Bay Number:
Controller Line Number:
Controller VPI:
Controller VCI:
Controller In Alarm:
Controller Error:
MGX8850
MGX8850
Number of Controllers:
Controller Name:
Controller Id:
Controller Location:
Controller Type:
Controller Logical Slot:
Deleting a Controller
To delete a controller, use the following procedure.
Establish a configuration session at any user access level.
Step 1
Step 2
Enter the delcontroller command to prevent the switch from using a specified controller.
mgx8830a.1.PXM.a > delcontroller <cntrlrId>
Replace <cntrlrId> with 2 to identify PNNI controller, or 3 to identify an LSC controller.
Caution
Do not enter the delcontroller command on a card with existing connections. If you do, those
connections cannot be recovered until the controller is re-added using the addcontroller command, and
the cards or the entire node is reset. Otherwise, ports remain in the provisioning state.
Step 3
To verify that the switch is no longer using the specified controller, enter the dspcontrollers command.
Note
Viewing an ATM Port Configuration
To view the configuration of an ATM line or trunk port, use the following procedure.
Step 1
Establish a CLI management session at any user access level.
To display a list of the ports already configured on a PXM1E or AXSM card, enter the following
Step 2
command:
mgx8830a.1.PXM.a > dspports
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
The delcontroller command does not delete the controller software, but directs the switch not
to use it.
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
0
0
0
0
NO
System Rev: 02.00
Jul. 30, 2000 09:39:36 GMT
1
PNNITWO
2
Internal
PNNI
7
Viewing an ATM Port Configuration
Shelf Alarm: NONE
9-45
Advertisement
Table of Contents
Troubleshooting
