Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual page 41

About This Guide
Table 3 Descriptions of Technical Manuals and Release Notes for Cisco Multiservice Switch Products (continued)
Document Title
Cisco MGX Route Processor Module (RPM-PR) Installation
and Configuration Guide, Release 2.1
78-12510-02
Cisco PNNI Network Planning Guide for MGX and SES
Products
OL-3847-01
Cisco Service Expansion Shelf Hardware Installation Guide,
Release 1
DOC-786122=
Cisco SES PNNI Controller Command Reference, Release 3
DOC-7814260=
Cisco SES PNNI Controller Software Configuration Guide,
Release 3
DOC-7814258=
Cisco Voice Interworking Services (VISM) Configuration
Guide and Command Reference, Release 3.2
OL-4359-01
Cisco Voice Switch Services (VXSM) Configuration and
Command Reference Guide for MGX Switches, Release 5
OL-4625-01
Cisco WAN Manager Database Interface Guide, Release 15
OL-4587-01
Cisco WAN Manager Installation Guide, Release 15
OL-4550-01
Cisco WAN Manager SNMP Service Agent, Release 15
OL-4551-01
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Description
Describes how to install and configure the Cisco MGX Route
Processor Module (RPM/B or RPM-PR) in the
Cisco MGX 8850 (PXM1), the Cisco MGX 8250, and the
Cisco MGX 8230 edge concentrators. Also provides site
preparation procedures, troubleshooting procedures,
maintenance procedures, cable and connector specifications,
and basic Cisco IOS configuration information.
Provides guidelines for planning a PNNI network that uses
Cisco MGX 8830, Cisco MGX 8850 (PXM45 and PXM1E),
Cisco MGX 8950, or Cisco BPX 8600 switches or the
MGX 8880 Media Gateway. When connected to a PNNI
network, each Cisco BPX 8600 Series switch requires an SES
for PNNI route processing.
Provides instructions for installing and maintaining an SES
controller.
Describes the commands used to configure and operate the
SES PNNI controller.
Describes how to configure, operate, and maintain the SES
PNNI controller.
Describes how to install and configure the Voice
Interworking Service Module (VISM) in the Cisco
MGX 8830, Cisco MGX 8850 (PXM45), and Cisco MGX
8850 (PXM1E) multiservice switches. Provides site
preparation procedures, troubleshooting procedures,
maintenance procedures, cable and connector specifications,
and Cisco CLI configuration information.
Describes the features and functions of the new Voice Switch
Service Module (VXSM) in the Cisco MGX 8880 Media
Gateway and in the Cisco MGX8850 (PXM45 and PXM1E)
multiservice switches. Also provides configuration
procedures, troubleshooting procedures, and Cisco CLI
configuration information.
Provides information about accessing the CWM Informix
database that is used to store information about the network
elements.
Provides procedures for installing Release 5 of the CWM
network management system.
Provides information about the CWM Simple Network
Management Protocol service agent, an optional adjunct to
CWM that is used for managing Cisco WAN switches
through SNMP.
Documentation
xli