Configuring Offline And Online Diagnostics Tests On Pxm1E And Axsm Cards; Table 9-35 Cnfdiag Command Parameters - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Managing PXM1E and AXSM Card Diagnostics

Configuring Offline and Online Diagnostics Tests on PXM1E and AXSM Cards

Enter the cnfdiag command as follows to enable online diagnostics tests on PXM1E or AXSM cards:
MGX.7.PXM.a > cnfdiag <slot> <onEnb> <offEnb> [<offCover> <offStart> <offDow>]
Table 9-35
cards.

Table 9-35 cnfdiag Command Parameters

Parameter
slot
onEnb
offEnb
offCover
offStart
offDow
Warning Do not remove the active PXM while the offline diagnostic is running on the redundant PXM. If you
remove it, the redundant PXM reboots but will not be able to become active unless its hard disk
drive was previously synchronized to the hard disk on the previously active PXM.
Example 9-1
In the following example, the user enables online diagnostics only for the PXM1E in slot 7.
MGX.7.PXM.a > cnfdiag 7 enable disable
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
9-84
tells you how to set these parameters to run online diagnostics tests on PXM1E and AXSM
Configuring online diagnostics only
Chapter 9
Description
Enter the slot of the card for which to configure
the diagnostics. For the PXM1E, the slot number
will be 7 or 8.
Enter enable to enable online diagnostic on the
card. Enter disable to disable online diagnostics.
Enter enable to enable offline diagnostics. Enter
disable to disable offline diagnostics.
Set the offline diagnostics coverage time to light,
medium, or full.
light = 5 minutes or less
medium = 30 minutes or less
full = any number of minutes-no limit
You do not need to set this parameter if
Note
you are not enabling offline diagnostics.
Set the time for the offline diagnostics to begin
using 24 hour time. The format is: hh:mm. For
example: 03:45 or 22:30
You do not need to set this parameter if
Note
you are not enabling offline diagnostics.
Sets the day of the week for the offline diagnostics
to run. The format is SMTWTFS.
Note You do not need to set this parameter if
you are not enabling offline diagnostics.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Switch Operating Procedures