Selecting A Card Sct - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 4 Preparing Service Modules for Communication
Note
To verify that the redundancy relationship is established, enter the dspred command as shown in the
Step 5
following example:
pop20two.7.PXM.a > dspred
pop20two
MGX8850
Primary
SlotNum
-------
1
7
15
31
The secondary state for the card in the secondary slot changes to Standby only when the secondary card
is ready to take over as active card. After you enter the addred command, the switch resets the secondary
card. When you first view the redundancy status, the state may be Empty Resvd or Init. The secondary
card may require one or two minutes to transition to standby.
Note
For information on managing redundant cards, see the
Chapter 9, "Switch Operating Procedures."

Selecting a Card SCT

A Service Class Template (SCT) is a configuration file that defines the traffic characteristics of the
various class of service queues in AXSM and FRSM12 service modules. The same card SCT may be
used for multiple cards of the same card type.
An SCT must be registered before you can select it for a card or port. For instructions on registering
Note
SCTs, see
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
When MPSM cards are installed on the switch, the addred command will fail if there are not
enough licenses on the secondary card (1:N redundant configurations) or in the license pool to
match the licenses already in use on the primary card. For example, if the primary card is
configured to use the ABR rate control feature, and if the configuration of other primary cards
has not already added a ABR rate control license to the secondary card, the secondary card will
require an ABR rate control license from the license pool. If no license is available, the addred
command fails.
Primary Primary
Type State
------- ---------
AXSM Active
PXM45 Active
SRM-3T3 Empty Res
SRM-3T3 Empty Res
The dspcds command also shows the redundancy relationship between two cards.
"Registering SCT Files"
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
System Rev: 02.01
Secondary Secondary Secondary
SlotNum Type
--------- --------- ---------
2 AXSM
8 PXM45
16 SRM-3T3
32 SRM-3T3
"Managing Redundant
in Chapter 7, "Managing Service Class Templates."
Selecting a Card SCT
Feb. 06, 2001 11:24:53 PST
Node Alarm: NONE
Redundancy
State Type
----------
Standby 1-1
Standby 1-1
Empty Resvd 1-1
Empty Resvd 1-1
Cards" section in
4-9